A multi-line industrial group operating captive power boilers, a hazardous-waste incinerator and a coating workshop rebuilt its continuous emission monitoring (CEMS) capability after an ultra-low emission upgrade. The customer had previously used one generic configuration on every stack, but after the retrofit three stacks behaved very differently: dust below 5 mg/m3 after bag filtration, high moisture after wet flue gas desulfurization, and a hydrogen chloride limit below 10 mg/m3. The team requested an engineering review of the available CEMS analysis technology routes and a stack-by-stack recommendation instead of a one-size-fits-all analyzer.
Eight product families were screened across four domains.
| Parameter | AG-DUST07 extractive forward scattering | Conventional backward scattering |
|---|---|---|
| Scattering direction | Forward, 0-90 degrees | Backward, about 180 degrees |
| Signal strength | Strong, 5-10x the backward signal | Relatively weak |
| Low-concentration sensitivity | Excellent, suitable below 5 mg/m3 | Moderate, suitable above 10 mg/m3 |
| Flue interference | None, heated measuring cell is independent | Affected by velocity, temperature and mist |
| Maintenance | Off-line, no production stop | Requires shutdown or stack access |
The two extractive routes differ in one decisive respect: whether the sample is dehumidified. Cold-dry AG-CEMS07II uses a chiller and an electrochemical oxygen cell; hot-wet AG-CEMS09 keeps the whole sample path above dew point and uses a zirconia analyzer.
| Dimension | Cold-dry (AG-CEMS07II) | Hot-wet (AG-CEMS09) |
|---|---|---|
| Sample state | Dry gas after condensation | Heated wet gas, no condensation |
| Dissolution loss | Present for SO2 and NO2 | Eliminated |
| Measurement basis | Dry basis | Wet basis, matching emission limits |
| O2 measurement | Electrochemical, 1-2 year life | Zirconia, 5+ year life |
| Best fit | Conventional sources, medium to high concentration | Wet FGD outlet, high moisture, low concentration |
The AG-CEMS08 tunable diode laser route uses narrow single-line absorption, delivering ppb-level detection limits with virtually zero cross-interference from moisture and other flue components, plus second-level response. It was the only route in the review able to meet an HCl limit below 10 mg/m3 on an incinerator stack.
| Stack / Scenario | Configuration | Rationale |
|---|---|---|
| Boiler after bag filter, ultra-low dust | AG-DUST07 + AG-CEMS09 | Forward scattering for low dust, hot-wet route avoids SO2 loss |
| Conventional boiler stack | Backward scattering + AG-CEMS07II + AG-YII21 | Economical coverage of dust, SO2, NOx, O2, CO and CO2 |
| Hazardous-waste incinerator | AG-DUST07 + AG-CEMS09 + AG-CEMS08 | Low dust, wet-basis gases and TDLAS for HCl |
| Coating line VOCs | AG-NMHC07 on-line + AG-GC07 periodic | Continuous totals plus speciation for process control |
Each route was validated with zero and span calibration plus wet-basis versus dry-basis checks.
Selection is not about better or worse analyzers but about matching principle to stack conditions: forward scattering at ultra-low dust, hot-wet sampling at high moisture and low concentration, TDLAS for trace HCl, NDIR for routine CO and CO2, and the two FID routes split between speciation and continuous totals. Screening on concentration, moisture, regulatory basis and maintenance capacity before choosing a model keeps a CEMS project inside budget and inside compliance.